Thesis jointly supervised by the University of Bordeaux I. PhD jointly supervised by: Hélène BUDZINSKI, CNRS - UMR 5805 in Bordeaux
Committee: Valérie CAMEL, Pierre DOUMENQ, Patrick MAZELLIER, Stéphane LE FLOCH
Abstract: The presence of hydrocarbons in the environment either as a result of oil spills at sea or due to chronic discharge is a major concern because of their ecotoxicity and their potential to bioaccumulate and thus enter the food chain. Therefore, these molecules are closely monitored and reliable analytical methods are required to identify and quantify them, for concentrations ranging from mg/L to ng/L. However, in most cases, laboratory analyses of hydrocarbons, especially aromatic hydrocarbons, are limited to the quantification of 16 polycyclic aromatic hydrocarbons (PAHs) identified by the U.S. Environmental Protection Agency (U.S. EPA) as hazardous to the environment due to their carcinogenic nature. However, polycyclic aromatic sulphur heterocycles (PASHs) and their substituted homologs are, in chemical terms, structurally similar to PAHs, and therefore can pose similar environmental risks, i.e. they can be carcinogenic or mutagenic. In this context, the research work carried out aims to develop methodologies for the extraction and analysis of a wider range of PAHs, PASHs and their alkyl derivatives directly in oil or dissolved in the aqueous phase. Extraction protocols by stir bar sorptive extraction (SBSE) and solid phase microextraction (SPME), and methods of analysis by gas chromatography coupled with mass spectrometry (GC-MS) and with tandem mass spectrometry (GC-MS-MS) have been developed. The results argue in favor of these methodologies both in terms of linearity of the response and in terms of sensitivity. These methodologies that have been successfully applied for the determination of analytes of interest in the water accommodated fraction and water soluble fraction prepared in the laboratory (WAF and WSF). For GC-MS-MS, while it is particularly suitable because it provides an additional level of selectivity, it is a difficult technique to implement, in particular in the case of molecules for which no calibration solutions are available. To overcome this difficulty, a reference oil containing all the target molecules was characterized. For alkylated compounds that are not commercially available, approximations were made by simple MS, based on comparative analysis of response coefficients in MRM (Multiple Reaction Monitoring) and SIM (Single Ion Monitoring) modes. The finalized method was used to characterize the Erika fuel oil, with low variability in the results. This product can be used as a reference for the quantitative analysis of all the families of molecules identified in this study.
Bibliographical reference: www.cedre.fr/pmb/opac_css/index.php?lvl=notice_display&id=9279